Filter
Top Products
62
Setting Using Internet Explorer
Details Page
This page is for performing detailed network setting.
This page can be used during access using AadminB.
● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the current value.
Setting (continued)
A
C
D
E
F
G
B
The model illustrated in the diagram is VN-V26U.
A JPEG TOS(DS field) For setting the TOS value of IP packets in which JPEG is stored.
The upper six bits out of the eight bits that make up the TOS value belong to DSCP.
This upper six bits can be set. The lower two bits are “0”. For example,
upon setting to “255”, the lower two bits are converted to “0”, and the
value becomes “252”.
TOS values are used in networks that support QoS. By setting QoS for
the network switch, routing can be done by giving priority to packets with
a larger TOS value.
B MPEG4 TOS(DS field) For setting the TOS value of IP packets in which MPEG4 is stored.
For details, refer to the [JPEG TOS(DS field)] item above.
C Audio TOS(DS field)
(VN-V26U only)
For setting the TOS value of IP packets in which Audio is stored.
For details, refer to the [JPEG TOS(DS field)] item above.
D TTL Unicast
For setting the TTL value of JPEG/MPEG4 packets that are to be sent via
TCP.
E TTL Multicast For setting the TTL value of JPEG/MPEG4 packets that are to be sent
via multicast.
F MTU For setting the maximum packet size for storing JPEG/MPEG4.
[Setting range: 1280 ~ 1500]
G Negotiation For setting the negotiation of the network.
When a value other than AAutoB is selected, do not set the network
device to be connected to AAutoB. Ensure that it is set to the same value
as VN-V25U/26U.
VN-V25U_26U_EN.book Page 62 Friday, January 18, 2008 2:56 PM