Filter
Top Products
Troubleshooting
40
Computer/connectivity problems
You cannot take
a picture
■ Turn the camera off, then on again.
■ Press the Shutter button all the way (page 8).
■ Battery is exhausted. Recharge the battery or insert a new
one (page 2).
■ Wait until the ready light is green before attempting to
take another picture.
■ Transfer pictures to the computer (page 37), delete
pictures from the camera (page 25), switch image-storage
locations (page 19), or insert a card with available
memory (page 7).
Picture orientation is
not accurate
■ Set the Orientation Sensor (page 21).
Flash does not fire
■ Check flash setting, and change as needed (page 14).
Battery life is short
■ Recharge the battery fully or insert a new one (page 2).
Camera displays an
error code
■ Press the Shutter button all the way (page 8).
■ Battery is exhausted. Recharge the battery fully (page 2).
■ Wait until the ready light is green before attempting to
take another picture.
■ Transfer pictures to the computer (page 37), delete
pictures from the camera (page 25), switch image-storage
locations (page 19), or insert a card with available
memory (page 7).
■ Contact your local service provider or visit
www.kodak.com/go/support.
If... Try one or more of the following
The computer does
not communicate with
the camera
■ Turn on the camera.
■ Recharge the battery or insert a new one (page 2).
■ Make sure USB cable is securely connected on camera and
computer port (page 37).
■ Try another USB port on the computer.
■ Make sure the EasyShare software is installed (page 31).
■ See the EasyShare software Help.
If... Try one or more of the following