Filter
Top Products
100
Connecting the camera to a computer
A fully charged battery should be used when the camera is connected to a computer. The use of the
AC adapter set (sold separately) is recommended over the use of the battery. For users with
Windows
®
98 or 98SE, read the section on page 102 on how to install the necessary USB driver
before connecting the camera to a computer.
5Turn on the camera to initiate the USB connection. While the
camera is connected to a computer, the data-transfer screen
will be displayed.
4. Attach the other end of the USB cable to
the computer’s USB port. Make sure the
plug is firmly attached. The camera should
be connected directly to the computer’s USB
port. Attaching the camera to a USB hub may
prevent the camera from operating properly.
3. Slide the USB-port cover open. Insert the small plug of
the USB cable into the camera. Make sure the plug is
firmly attached.
1. Start up the computer. The computer must be turned on before connecting the camera.
2. Insert the memory card into the camera. To change the memory card while the camera is con-
nected to a computer, see page 108.
DATA-TRANSFER MODE