Filter
Top Products
14 GETTING UP AND RUNNING
GETTING UP AND RUNNING
Inserting the lithium-ion battery
This digital camera uses one NP-200 lithium-ion battery. Before using the battery, read
the safety warnings on pages 3 and 4 of this manual. When replacing the battery, the
camera should be turned off.
Slide the battery-chamber door toward the front of the camera to release
the safety catch (1). Open the door.
Move the battery latch towards the back of the camera to insert
the battery (2). Slide the battery into the battery chamber with the
battery terminals first until it is caught by the latch.
To remove the battery, move the latch towards the back of the
camera until the battery is released (3). Pull the battery out of
the chamber.
Close the battery-chamber door (4) and slide it toward the
back of the camera to engage the safety catch.
After installing the battery, the set-time/date message may
appear on the monitor. The clock and calender is set in
section 3 of the setup menu (p. 20). An internal battery
protects the clock, calender, and memory settings for more
than 24 hours if the camera is used for at least 5 minutes
before removing the battery.
1
2
3
4