Filter
Top Products
120 DATA-TRANSFER MODE
Connecting the remote camera
Before the camera can be connected to a computer, the remote camera driver must be installed,
see page 118. A fully charged battery should be used when the camera is connected to a computer.
The use of the AC adapter set (sold separately) is recommended over the use of the battery. For
users with Windows 98SE, the USB driver must be installed before connecting the camera to a
computer (p. 102).
4. Attach the other end of the USB cable to the computer’s USB port. Make
sure the plug is firmly attached. The camera should be connected directly to
the computer’s USB port. Attaching the camera to a USB hub may prevent the
camera from operating properly.
3. Slide the USB-port cover open. Insert the small plug of
the USB cable into the camera. Make sure the plug is
firmly attached.
1. Select Remote Camera from the transfer mode option in section
3 of the setup menu.
2. Start up the computer. The computer must be turned on before
connecting the camera.
To view the live image on the computer, follow the instructions for
the application used. Refer to the application’s instruction manual
or help section for details.
5Turn on the camera to initiate the USB connection. A live image is
displayed on the monitor.
Reset default
Date/Time set
Date format
Transfer mode
–
–
Data storage
RemoteCamera
PictBridge
Remote Camera