Filter
Top Products
12
Follow these steps to connect power. The
switchplate supplies power to the antenna.
a. Before you begin, disconnect vessel power.
b. Connect a power cable to 12 VDC vessel
power (for cable specifications, see Figure 3
on page 3).
c. Connect your vessel power wires to the
power (+) and ground (-) input terminals on
the switchplate (see Figure 22).
CAUTION
For your own safety, disconnect vessel power
and make sure the circuit is dead before you
connect any power wires.
Power supplied to the antenna must not fall
below 11 VDC or exceed 16 VDC.
IMPORTANT!
11-16 VDC
Ground
Vessel Power
+
–
Figure 22: Switchplate Wiring - Vessel Power Cable
Connect Power
10