Filter
Top Products
23
The satellite library in the TracVision antenna
includes two slots for user-defined satellites
(USER 1 and USER 2). You can program one or
both of these library slots for any satellite you
wish that is not already set up in the library.
To configure a user-defined satellite, you will
need to program into the antenna the following
information about the satellite (see Figure 34):
• Satellite name
• Satellite longitudinal position
• Transponder information for all
combinations of polarization and band:
•vertical high
•vertical low
• horizontal high
• horizontal low
OR
•right
•left
•Frequency
•Symbol rate
•FEC code rate
• Network ID
•Decoder type
NOTE: You can find this satellite information on the
web at www.lyngsat.com or www.satcodx.com
(neither website is affiliated with KVH).
Name
Longitude
Decoder type
Vertical High: Vertical Low:
Frequency Frequency
Symbol rate Symbol rate
FEC code FEC code
Network ID Network ID
Horizontal High: Horizontal Low:
Frequency Frequency
Symbol rate Symbol rate
FEC code FEC code
Network ID Network ID
Figure 34: Identifying a Linear Satellite
User-Defined Satellites
C
Appendix