Filter
Top Products
2
Procedures for close-up flash operation (using cords)
114
Checking the illumination before actually taking pictures
(Modeling Illumination) in close-up flash operation (using
cords)
Press the Target Light button on the SU-800 and
release within one second and the SB-R200’s flash
fires repeatedly at a reduced flash output level. This is
useful for checking the illumination and the shadows
cast on the subject before actually taking the picture.
Using the Target Light (Focus-assist Illuminator) in
close-up flash operation (using cords)
Press the Target Light button on the SU-800 for more
than one second, the Target Light on the SB-R200
lights up.
• The Target Light illuminates for 60 seconds and goes out
automatically. To cancel the illumination within 60 seconds,
press the Target Light button again for more than one
second.
• The Target Light also goes out when:
Releasing the shutter
Test firing
Firing the Modeling Illuminator
Pressing the [ON/OFF] button
• Pressing the Target light button on the SB-R200 is invalid.
READY
LOCK
SEL
READY
LOCK
SEL