Filter
Top Products
75
Details on close-up flash operation and
shooting procedures
5
Setting the SB-R200’s flash output level ratio
between Groups A and B (in TTL mode).
Press the [SEL](FUNC.) button to display flash
output level ratio (blinking), then press the [] or
[] button to increase or decrease the ratio. Press
the [SEL](FUNC.) button once again and the flash
output level ratio stops blinking. The last value to
blink is the one that has been set automatically.
• The flash output level ratio can be set from 8:1 to 1:8.
• As the ratio changes, the flash output level indicator
bar varies.
• Continuously pressing the [] or [] button quickly
increases or decreases the ratio.
• The flash output level ratio blinks during adjustment
and stops after blinking six times unless an adjustment
is made. The last value to blink is the one that has
been set automatically.
6
Setting the SB-R200’s flash output level
compensation value (in TTL mode).
Press the [SEL](FUNC.) button to display the flash
output level compensation value (blinking). Press
the [] or [] button to increase or decrease the
compensation value. Press the [SEL](FUNC.)
button once again and the flash output level stops
blinking. The last value to blink is the one that has
been set automatically.
• The same flash output level compensation value is set
for both Groups A and B.
• The flash output level compensation values can be set
in 1/3 step increments or decrements from +3.0 to
-3.0 EV.
• The values are displayed in decimal format, like 0.3 for
1/3, and 0.7 for 2/3.
• Continuously pressing the [] or [] button quickly
increases or decreases the value.
• The flash output level blinks during adjustment and
stops after blinking six times unless an adjustment is
made. The last value to blink is the one that has been
set automatically.