Filter
Top Products
39
Flash operation using the R1C1
2
Setting up the SB-R200.
1
Install the battery in the SB-R200 in the same way as No. 3 in
“Procedures for close-up flash operation.” (p. 30)
2
Slide the SB-R200’s Mounting Foot
into the AS-20’s Speedlight
Mounting Shoe and slide the lock
switch.
The Mounting Foot cannot be inserted in
reverse.
• Slide the lock switch until it stops and make
sure that the red part can no longer be seen.
3
Set up the SB-R200.
As a basic guide, the
effective shooting distance
between the Master/
Commander unit and the
SB-R200 is approx. 4m
(13.1 ft.) or less in the front
position, and approx. 3m
(9.8 ft.) at both sides.
These ranges vary slightly
depending on conditions
and/or ambient light.
• Be sure to place all SB-R200 units that are set in the same group close together.
• The set up range of the SB-R200 units vary depending on the Commander unit (camera,
Speedlight, etc.) For details, see your Speedlight or camera’s instruction manual.
• For notes on setting up the SB-R200, see “Setting up the SB-R200” on page 108.
A
S
-
2
0
LOCKL
OCK
30˚
30˚
Group A
Group C
Group B
With the SU-800
Commander
unit
3m (9.8ft.)
3m (9.8ft.)
4m
(13.1ft.)