Filter
Top Products
3 Procedures for close-up flash operation
76
7
Setting the manual flash output level for group C.
Press the [SEL](FUNC.) button to display manual
flash output level (blinking) for group C, then
press the [] or [] button to increase or
decrease the value. Press the [SEL](FUNC.)
button once again and the flash output level stops
blinking. The last value to blink is the one that has
been set automatically.
• Manual flash output level can be set separately for
each group.
• The flash output level can be set from M1/1 to M1/64.
(M1/8 is preset when shipped from the factory.)
• Press and hold the [] or [] button to quickly
increase or decrease the value.
• The flash output level ratio blinks during adjustment
and stops after blinking six times unless an adjustment
is made. The last value to blink is the one that has
been set automatically.
8
Setting a channel number on the SU-800.
Set the communication channel numbers of the
SU-800 and SB-R200. Press the [SEL](FUNC.)
button to display the channel number (blinking).
Press the [] or [] button to set the channel
number. Press the [SEL](FUNC.) button once
again and the channel number stops blinking. The
last channel number to blink is the one that has
been set automatically.
• Select one of the four available channels. The same
channel number is set for all groups.
• The channel number blinks during adjustment and
stops after blinking six times unless an adjustment is
made. The last channel number to blink is the one that
has been set automatically.
9
Setting a channel number on the SB-R200.
Rotate the [CHANNEL] select dial on the SB-R200
to set the channel number. Be sure to set the
same channel number as set on the SU-800.
CHANNEL
2
3 4
1