Nikon SB-700 Camera Flash User Manual


 
D28
Wireless Multiple Flash-unit Photography
D
Master
ash unit
Remote ash unit
Speedlight status
Flash-ready
indicator
Flash-ready
indicator
Sound
monitor
Blinks for
approx.
3 sec.
Quickly
blinks for
approx.
3 sec.
Three long
beeps for
approx.
3 sec.
Insuf cient ash output for
correct exposure
*1
Underexposure due to insuf cient
ash output may have occurred.
To compensate, use a wider
aperture or higher ISO sensitivity,
or move the ash unit closer to
the subject and reshoot.
Goes out
and lights
up when
ready to re
Quickly
blinks for
approx.
6 sec.
High and
low tone
beeps
alternate
for
approx.
6 sec.
• Auto aperture ash mode or
non-TTL auto ash mode is
set on the master ash unit.
Change the ash mode to an
operable ash mode.
• The remote ash unit light
sensor has failed to receive the
command light from the master
ash unit. This is because the
light sensor cannot detect when
to stop ring in sync with the
master ash unit, either due to a
re ection from the remote ash
unit itself or light from another
remote ash unit that may
have entered the light sensor
window. Change the direction
or position of the remote ash
unit and reshoot.
Checking Status in Wireless Multiple Flash-unit Photography