Filter
Top Products
113
For your
reference
Updating the drivers installed in the unit
The driver can be updated using either of the following two methods.
1. Checking the current version of the driver and performing the update using the dedicated tool
(P2_Status_Logger)
PASS (P2 Asset Support System) is only available to customers who have completed customer
registration with Panasonic.
Log in to PASS and use the dedicated tool (P2_Status_Logger) to check the version information of the
driver on the unit and download links to pages containing the necessary drivers.
For further information about downloading and using P2_Status_Logger, log in to PASS and refer to the
relevant pages.
Besides access to PASS, completing customer registration has a number of other benefits. For further
details, refer to the PASS (P2 Asset Support System) website (http://panasonic.biz/sav/pass_e/).
2. Checking the current version of the driver using the unit and performing the update
From the MAINTENANCE menu page, check the current version of the driver on the unit using the
setting menu “DIAGNOSTIC”–“VERSION”. Then, access the website listed below for the latest driver-
related information and download the driver as required.
■
Notes
The update is completed by loading the downloaded file onto the unit via an SD card. For further details
about the updating methods, refer to the following website.
https://eww.pavc.panasonic.co.jp/pro-av/
Be sure to use a compatible SD card. The unit is compatible with SD cards based on the SD and SDHC
standards. Also, be sure to format the memory card using the unit before use.
•
•
Maintenance
Do not use benzine or paint thinners to clean the unit.
Doing so may deform the unit or cause its paint to peel off.
Before cleaning the unit, remove the battery or unplug the AC cord from the power outlet.
Wipe the unit with a clean soft cloth. To remove stubborn dirt, dip a cloth into some kitchen detergent
which has been diluted with water, wring it out and wipe off the dirt, and then use a dry cloth to take up
any remaining moisture.
•
•
•
Condensation
When condensation forms on or inside the unit, the principle behind its formation is the same as when
droplets of water form on the window panes of a heated room. It forms when the unit and its cards are
brought into a space with significantly different temperature and humidity levels, specifically when:
They have been brought to a very humid location full of steam or to a room immediately after the heating
has been turned on.
They have suddenly been brought from an air-conditioned place to a location with high temperature and
humidity levels.
If the unit and its cards are brought to such locations, do not turn on the unit’s power but leave the unit and
cards standing for about 10 minutes.
•
•