Filter
Top Products
68
Switching to the USB HOST mode
1 Hold down [POWER] for at least 1 second to
turn the power on.
The thumbnail screen now appears.
2 Press [THUMBNAIL/MODE] to display the
normal display screen.
3 Press [MENU/MODE CHK].
4 Using , and , select “OTHER
FUNCTIONS” – “PC MODE SELECT”, and
press .
5 Using and , select “USB HOST”, and
press .
6 Press [MENU/MODE CHK] twice to display
the normal display screen.
7 Hold down [THUMBNAIL/MODE] for at least
2 seconds.
The USB HOST mode is now established,
and “USB HOST” appears at the bottom of the
thumbnail screen.
Use a hard drive with enough memory to
accommodate the data to be copied.
To exit the USB HOST mode
1 Hold down [THUMBNAIL/MODE] for at least
2 seconds.
The USB HOST mode is cancelled, and “USB
HOST” disappears at the bottom right of the
screen.
•
Usable hard drives
The following hard drive can be used.
Panasonic portable hard disk unit for P2 store (AJ-PCS060G)
Any hard drive which can be connected using USB 2.0
USB bus power (5 V, 0.5 A) is also supported, but some hard drives cannot be started up using it. If this
is the case, supply power from a separate source to the hard drive.
Some hard drives may not operate properly.
Do not use USB memories or other removable media.
•
•
•
•
•
Copying data from P2 cards to the hard drive (continued)