Filter
Top Products
–48–
Warning/Status Displays in the Viewfinder and Display Window
Changing the setting menu configuration
The setting menu can be configured by selecting only the pages necessary for the application.
Pages are selected using the MENU SELECT page of the engineer menu mode.
When using the engineer menu, switch the unit to engineer mode as described below.
The unit is switched to user mode by setting the MENU SET/OFF switch to “SET”.
The unit is switched to engineer mode by holding down the SHIFT/ITEM and UP buttons simul-
taneously and setting the MENU SET/OFF switch to SET.
The user and engineer modes differ as follows.
User mode: Only the selected pages the setting menu can be used. The data set on each
page is written to the non-volatile memory, allowing it to be stored for extend-
ed periods of time.
Engineer mode: All pages contained in the setting menu can be used. In addition, the data set
at each page is written to the non-volatile memory, allowing it to be stored for
extended periods of time.
After completing the adjustments and settings with engineer mode, configuring a menu consist-
ing only of frequently used pages allows the necessary pages to be called quickly.
(The method is selected using the menu selections on pages 121 to 123.)