– 134 –
Specifications
VTR Section
VTR Video System (during playback on a standard playback unit)
Bands: Y; 30 Hz to 5.75 MHzo1.0 dB/p3.0 dB
P
B, PR; 30 Hz to 2.75 MHz o1.0 dB/p3.0 dB
S/N ratio: Better than 55 dB
K factor (2T pulse): Within 2%
Y/C delay: Within 20 ns
VTR Audio System (during playback on a standard playback unit)
Sampling frequency: 48 kHz (synchronized to video)
Quantization: 16-bits/sample
Frequency response: 20 Hz to 20 kHzt1.0 dB (at the reference level on MIC
LOWCUT OFF status of the Setting Menu)
Dynamic range: 85 dB or more (at 1 kHz, AWTD)
Distortion: Within 0.1% (at 1 kHz, reference level)
Wow/flutter: Below measurable limit
Head room: 20 dB
Emphasis: T1r50 Øs, T2r15 Øs (can be turned ON/OFF)
VTR Tape Running System
Tape used: DVCPRO format 1/4-inch M-size cassette tape
Tape speed: 67.640 mm/s (50 Mbps)
33.820 mm/s (25 Mbps)
Recording/playback time: Approx. 33 min. (50 Mbps, using the AJ-P66MP)
Approx. 66 min. (25 Mbps, using the AJ-P66MP)
FF/REW time: Approx. 3 min. (using the AJ-P66MP)
Connectors
Input
AUDIO IN CH1/CH2
(XLR∑2, 3-pin, female): MIC/LINE switchable, balanced, more than 10 kohm
MIC; Menu setting to p60/p50/p40 dBu,
LINE; Menu setting to p6/0/o4 dBu
MIC IN (XLR, 3-pin, female): Phantom o48 V, p60 dB, balanced, 3 kohm
Menu setting to p60/p50/p40 dBu
GENLOCK IN (BNC) 1.0 Vp-p, 75 ohm
TIME CODE IN (BNC): 0.5 to 18 Vp-p, high-impedance
Output
CAMERA OUT (BNC): 1.0 Vp-p, 75 ohm
VIDEO OUT (BNC): 1.0 Vp-p, 75 ohm
AUDIO OUT (CH1/CH2/MIX)
(XLR, 3-pin, male): o4 dBu, balanced, low-impedance
(CH1, CH2 or MIX selectable)
AUDIO CH1/CH2 OUT
(12-pin, multi connector)
(option): p20 dBu, unbalanced, low-impedance
TIME CODE OUT (BNC): 1.5 Vp-p, low-impedance
PHONES (mini-jack∑2):
Other
DC IN (XLR, 4-pin, male): DC 11–17 V
DC OUT (4-pin): DC 11–17 V, maximum rated current; 0.1 A
LENS (12-pin):
REMOTE (ECU, 6-pin):
Accessories
Shoulder belt (1)
Sony battery connector (screws included)
Weight and dimensions shown are approximate.
Specifications are subject to change without notice.