Filter
Top Products
–46–
ECUAQ
OUTPUT
GAIN
WHITE
BALANCE
AUTO W/B
BALANCE
9
0
-3
CAMERA
TEST
BAR
A
B
PRE
AWB
ABB
MANUAL AUTO
(dB)
SHUTTER
PAINTING
ON
OFF
ON
1/250
1/125
1/100
1/500
1/1000
1/2000
OFF
ECU
R B
R B
MASTER
PEDESTAL
IRIS
ON
OFF
PAGE
ITEM
UP
DWN
ON
SELECT CONTROL STORE
SET UP
GAIN
BLACK
-
Connecting the AQ-EC1 Extension Control Unit (Option)
Connecting the AQ-EC1 extension control unit (option) allows a portion of the camera section
functions to be operated by remote control.
When the AQ-EC1 is connected and the POWER switches of the unit and AQ-EC1 are set to
ON, the unit automatically enters remote control mode.
The handling instructions included with the AQ-EC1 describe operations for when the AQ-EC1 is
connected to an AQ series digital camera.
When the AQ-EC1 is connected to the AJ-PD900W, some functions differ, and some features
cannot be used.
|Notes{
¡The POWER switches of the unit and AQ-EC1 must be set to OFF before the 6-pin cable is
connected or disconnected.
¡All adjustments and settings made using the switches and controls other than the menu setting
section of the AQ-EC1 are erased when the unit’s POWER switch is set to OFF. Also, adjust-
ments and settings made using the AQ-EC1 cannot be written to setup cards. However, when
the AQ-EC1 is connected again, these settings return to the AQ-EC1 settings.
(Menu contents set with the menu setting section are saved.)
|Note{
The functions of the AQ-EC1 are limited as follows.
¡The STORE switch does not function.
(If the menu settings are changed while the AQ-EC1 is connected to the AJ-PD900W, the new
menu settings are saved automatically as soon as the changes are made.)
Note that the AQ-EC1 gain switch displays p3, 0 and 9 correspond to L, M and H, and the
OUTPUT switch settings CAMERA, TEST and BAR to CAM/AUTO KNEE ON, CAM/AUTO
KNEE OFF and BAR for each main unit.
¡The Synchro scan and Super V modes cannot be used while the AQ-EC1 is connected to the
unit.
¡The lens iris (IRIS) control of the AQ-EC1 is valid only when the lens iris AUTO/MANUAL se-
lector is set to AUTO.
6-pin Cable
ECU Connector
AQ-EC1