Filter
Top Products
12
13
• After confirmation, unit settings are initialized and it is automatically
restarted.
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
• To cancel initializing, select [n] and press <EXECUTE>.
• The version information is displayed.
• Press <SAVE/LOAD> to show the 8-digit version number split up in 3,
2 and 3 digits.
CAMERA
No.
DATA
SET
DISPLAY SELECT
UP
DOWN
SET UP
ND/CC M.GAIN/M.PED
SHUTTER
ND
M.GAIN
IRIS
M.PED 10-19
CC SHT SYNC
SELECT
EXECUTEEXIT
SAVE/LOAD
SHIFT
+
UP+DOWN
Press to select the menu numberPress to switch display
digits
Display digit indication (first 3 digits)
Display digit indication (middle 2 digit)
Display digit indication (last 3 digits)
Press to exit setup mode (hold down)
• To exit setup mode, hold down <EXIT> for about 2 seconds.
• To make other settings, press <SELECT> to select a menu number.
This functions are used by the manufacturer during maintenance.
CAMERA
No.
DATA
SET
DISPLAY SELECT
UP
DOWN
SET UP
ND/CC M.GAIN/M.PED
SHUTTER
ND
M.GAIN
IRIS
M.PED 10-19
CC SHT SYNC
SELECT
EXECUTEEXIT
SAVE/LOAD
SHIFT
+
UP+DOWN
Press to select the
menu number
Press to confirm
Select y (Save)/n (Cancel)
Press to exit setup mode
(hold down)
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
• The file is saved to the memory card and [Fin] appears when saving
ends.
• [E02] is displayed if the save operation to the memory card fails.
(→page 13)
If this happens, check the memory card and try again or insert
another memory card to perform the operation again.
• [E01] is displayed when a unit data file with the same name as the
one you are attempting to save already exists on the memory card.
To overwrite the file, press <UP> or <DOWN> to select [y] and
press <EXECUTE>. (→page 13)
• To exit setup mode, hold down <EXIT> for about 2 seconds.
• To make other settings, press <SELECT> to select a menu number.
For details on software upgrades, refer to "Software upgrades"(→page
3).
CAMERA
No.
DATA
SET
DISPLAY SELECT
UP
DOWN
SET UP
ND/CC M.GAIN/M.PED
SHUTTER
ND
M.GAIN
IRIS
M.PED 10-19
CC SHT SYNC
SELECT
EXECUTEEXIT
SAVE/LOAD
SHIFT
+
UP+DOWN
Select y (Upgrade)
Press to select the
menu number
Press to confirm
Press to exit setup mode
(hold down)
• Upgrading starts.
ND
M.GAIN
IRIS
M.PED
CC SHT SYNC
• When the upgrade ends, [Fin] appears.
If the upgrade fails for some reason, <SHIFT> may start to flash after
the restart. If this happens, perform the upgrade process again.