Filter
Top Products
O: Close the card/battery door.
_: Slide the release lever in the direction
of the arrow.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
O
Preparation
• Remove the battery after use. Store the removed battery in the battery carrying case
(supplied).
• Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the
settings on the camera may not be stored properly.
• The supplied battery is designed only for the camera. Do not use it with any other equipment.
• Before removing the card or battery, turn the camera off, and wait until the status indicator has
gone off completely. (Otherwise, this unit may no longer operate normally and the card itself
may be damaged or the recorded pictures may be lost.)
The following operations can be performed using this unit,
• When a card has not been inserted: Pictures can be recorded in
the built-in memory and played back.
• When a card has been inserted: Pictures can be recorded on the
card and played back.
• When using the built-in memory
f_'41_1 (access indication)
• When using the card
D (access indication)
The access indication lights red when pictures are being recorded
on the built-in memory (or the card),
• Memory size: Approx. 50 MB
• Recordable motion pictures: QVGA (320×240 pixels) only
• The built-in memory can be used as a temporary storage device when the card being used
becomes full,
• You can copy the recorded pictures to a card. (P82)
• The access time for the built-in memory may be longer than the access time for a card.
The following types of cards can be used with this unit.
(These cards are indicated as card in the text.)
VQT1M97 15