Filter
Top Products
- 141 -
Recording
Applicable modes:
Contrast and exposure will be adjusted automatically when there is a big difference in
brightness between the background and subject, to bring the image close to how you see.
Settings: [HIGH]/[STANDARD]/[LOW]/[OFF]
Note
•
Even when the [Sensitivity] is set to [100], [Sensitivity] may be set higher than [100] if the picture is
taken with [i.Dynamic] set to valid.
•Compensation effect may not be achieved depending on the conditions.
•[LOW], [STANDARD], or [HIGH] represents the maximum range of effect.
Applicable modes:
You can take a picture brightly in dark places by setting [Min. Shtr Speed] slower. Also, you can
set it faster to reduce the blur of the subject.
Settings: [AUTO], [1/250], [1/125], [1/60], [1/30], [1/15], [1/8], [1/4], [1/2]
¢
, [1]
¢
(DMC-FZ60)
¢ When [Sensitivity] is set to [2000], [2500], or [3200], the camera sets the shutter speed at [1/4].
Note
•
This should usually be set to [AUTO] to take pictures. (When you select a minimum shutter speed
other than [AUTO], [ ] appears on the screen.)
•When [AUTO] is selected, shutter speed may be set up to 1 second when there is not much jitter to
adjust with the [Stabilizer], or when [Stabilizer] is set to [OFF].
•Setting [Min. Shtr Speed] to slower speed might increase the chance of jitter, so we recommend
using a tripod and the Self-timer for taking pictures.
•Setting [Min. Shtr Speed] to faster speed might make the picture darker, so we recommend
recording the picture in well-lit area. If correct exposure cannot be achieved, [ ] will flash in red
when the shutter button is pressed halfway.
[i.Dynamic] (Intelligent dynamic range control)
[Min. Shtr Speed]
Minimum shutter speed setting 1/250 1
Brightness Darker Brighter
Jitter Less More