Filter
Top Products
VQT4P14
Application (Record)
Taking pictures with flash
- 60 -
■
Available types in each mode (○: Available, –: Not available, : Default setting)
[Scene Mode]
○
*
1
○ ○ ○ ○ ○
–
○ ○ ○ ○ ○
–
○ ○ ○ ○
– – –
○
– – –
–
○ ○ ○ ○ ○
–
○ ○ ○ ○ ○
–
○
– – – –
○
– – – – –
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
*
1
Set to , , or depending on the subject and brightness.
• The flash cannot be used when recording motion pictures or in the , , , ,
, , and Scene Modes.
■
Shutter speeds for each flash mode
1/60
*
2
- 1/2000th
1
*
3
- 1/2000th
*
2
Varies according to [Min. Shtr Speed] setting.
*
3
When [Min. Shtr Speed] is set to [AUTO], and a jitter is detected when [Stabilizer] is turned to
[ON], the maximum speed is 1/4 second. Also varies according to [Intelligent Auto] Mode and
Scene Modes, etc.
●
Do not put your hands over the light-emitting area of the flash (→8) or look at it
from close range.
Do not use the flash at close distances to other subjects (heat/light may
damage subject).
●
Edges of picture may become slightly dark if using flash at short distances without
using zoom (close to max. W). This may be remedied by using a little zoom.
●
The effect of red-eye reduction varies depending on the subject and is affected by
factors such as distance to the subject, whether the subject is looking at the camera
during preliminary flash, and so on. In some cases, the effect of red-eye reduction
may be negligible.
●
Flash settings may be changed when changing recording mode.
●
Scene Mode flash settings are restored to default when Scene Mode is changed.
●
No pictures may be taken if these marks (e.g. ) are flashing (flash is charging).
●
If light from the flash on a subject is insufficient, neither the proper exposure nor White
Balance is achieved.
●
The flash effect may not be sufficient in the following cases:
• Slow shutter speed
• is set
●
Flash charging may take time if battery is low or if using flash repeatedly.