Filter
Top Products
- 159 -
≥ When the write protect switch on the Eye-Fi card is on the LOCK side,
[PROTECT] is displayed and selected transfer setting is disabled.
Please unlock the write protect switch.
≥ The protect setting is also applied to the files for which [TRANSFER/
PROTECT] is set. To delete or rotate a file, first cancel [TRANSFER/
PROTECT] and then perform the operation.
≥ The [Eye-Fi] menu only appears when an Eye-Fi card is used.
≥ The Eye-Fi transfer feature cannot be guaranteed to continue to
operate in the future due to changes to the card specification etc.
≥ Update the firmware of the Eye-Fi card to the latest one using the
software supplied with the Eye-Fi card before use.
≥ Eye-Fi transfer is terminated when it goes into sleep mode by the
energy-saving function during the Eye-Fi transfer. Connect the AC
adapter and set the [AC:REC/PLAY] in [ECONOMY] to [60 min].
(l 65) (Energy-save function will disabled during the direct mode.)
≥ When the endless memory function of the Eye-Fi card is set to on, the
files transferred from the card may be deleted automatically.
≥ The Eye-Fi card may heat up as a result of the files being transferred.
≥ When the Eye-Fi card is used, the battery will run down faster.
≥ Audio files cannot be handled.
≥ The [Eye-Fi] setting can be checked from the recording standby screen
or the thumbnail screen (1-file display).
≥ When using the Eye-Fi card, please be sure to unlock the write-protect
switch. (l 33)
≥
Files cannot be transferred during motion picture recording or audio recording.
≥ Before deleting the files, please confirm they have been transferred to
your PC and uploaded to the sharing site.
≥ Do not use the Eye-Fi card in locations where the use of wireless
devices is forbidden, such as inside aircraft etc.
≥ Depending on network conditions, the transfer may take some time.
Also, if network conditions deteriorate, the transfer may be suspended.
≥ Files over 2 GB in size cannot be transferred. Such files should first be
split to reduce the file size. (l 113)
In [Eye-Fi], [TRANSFER] is set to [ON]
(Transferring in direct mode)
In [Eye-Fi], [TRANSFER] is set to [ON]
In [Eye-Fi], [TRANSFER] is set to [OFF]