Filter
Top Products
Others
94
VQT0U87
3: The LCD monitor flickers indoors.
• The LCD monitor may flicker for a few
seconds after turning the camera on
indoors under fluorescent light.
This is not a malfunction.
4: The LCD monitor is too bright or dark.
• Adjust the brightness of the screen.
(P21)
• Is the camera in high angle mode?
(P38)
5: Black, red, blue and green dots
appear on the LCD monitor.
• These pixels do not affect the recorded
pictures.
This is not a malfunction.
6: Noise appears on the LCD monitor.
• In dark places, noise may appear to
maintain the brightness of the LCD
monitor.
This does not affect the pictures you are
recording.
7: A vertical line appears on the LCD
monitor.
• This is a phenomenon called smear. It
is a characteristic of CCD and appears
when the subject has a bright part.
Uneven colors may also appear around
the smear. This is not a malfunction. It
is recorded in motion pictures but is not
recorded on still pictures.
∫ Flash
1: The flash is not activated.
• Is the flash setting set to Forced OFF
[]?
– Change the flash setting. (P39)
• The flash is not activated when motion
picture mode [ ], [SCENERY] (P50),
[NIGHT SCENERY] (P51),
[FIREWORKS] (P53) or [STARRY SKY]
(P53) in scene mode is selected.
2: The flash is activated 2 times.
• When you select red-eye reduction
(P39), the flash is activated once before
the actual recording to reduce the
red-eye phenomenon (eyes of the
subject appearing red in the picture)
and then activated again for the actual
recording.
∫ Playback
1: The picture being played back is
rotated and displayed in an
unexpected direction.
The camera has a function that
automatically rotates the display of
pictures recorded holding the camera
vertically. (If you take pictures when
aiming the camera up or down, the
camera may recognize that it is being
held vertically.)
• You can display the pictures without
being rotated when [ROTATE DISP.]
(P71) is set to [OFF].
• You can rotate pictures with the
[ROTATE] function. (P71)
2: The picture is not played back.
• Is the mode dial set to playback [ ]?
• Is there a picture on the built-in memory
or the card?
The pictures on the built-in memory
appears when a card is not inserted.
The picture data on the card appears
when a card is inserted. (P17)
3: The folder number and the file number
are displayed as [—] and the screen
turns black.
• Is the picture edited with a PC or
recorded with a digital camera from
another manufacturer?
This may also happen if batteries are
removed immediately after recording or
if recording with exhausted batteries.
– Format the data to delete the pictures
mentioned above. (P78) (Formatting
irretrievably deletes all data including
the other pictures. Check the data
carefully before formatting.)
VQT0U87ENG.book 94 ページ ２００５年１２月２７日 火曜日 午後７時１２分