Filter
Top Products
With a PC
66
LSQT0975
Using on Macintosh
ª Operating environment on iMovie 4/
iMovie HD
OS:
Mac OS X v 10.3 to v 10.4
CPU:
PowerPC G3 (400 MHz or higher), G4, G5
Interface:
DV (FireWire)
≥Supplied CD-ROM is available for Windows
only.
≥iMovie/iMovie HD, included with any new
Macintosh or sold with iLife.
≥For more information, please contact Apple
Computer, Inc. at http://www.apple.com.
ª
Copying still pictures on PC
1
Connect the Camcorder to the personal
computer via the supplied USB connection
cable.
2 Double-click [NO_NAME] or [Untitled]
displayed on the desktop.
≥Files are stored in [100CDPFP] folder in the
[DCIM] folder.
3 Using a drag-and-drop operation, move the
pictures you want to acquire or the folder
storing those pictures to any different
folder on the personal computer.
To disconnect USB cable safely
If USB cable is disconnected while the computer
is on, error dialog box may appear. In such a case
click [OK] and close the dialog box. By following
the steps below you can disconnect the cable
safely.
1 Double click the icon in task tray.
≥Hardware disconnect dialog box appears.
2 Select [USB Mass Storage Device] and click
[Stop].
3 Verify [Matshita DVC USB Device] is
selected and click [OK].
≥You can safely disconnect the cable.
Note on the driver name displayed
The driver name displayed will differ depending
on your OS, operating environment and the mode
of the Camcorder.
≥Make sure Camcorder’s Card Access Lamp is
off and disconnect the cable. Also, the icon will
not be displayed when in Tape Recording Mode
or Tape Playback Mode.
If the above operation is not performed correctly,
when data is copied from the personal computer
to an SD Memory Card, the copied data may be
damaged.
When the following operations are performed, the
same results will occur as when the USB cable is
incorrectly removed (above). Therefore, it is
imperative that the above operation is completed
before proceeding.
≥When SD Memory Card is removed.
≥When Camcorder power is turned OFF.
≥When Mode Dial is turned to change modes.
When using on Macintosh
Drag the [NO_NAME] or [Untitled] disk icon to the
[Trash], and then disconnect the USB connection
cable.
If you no longer need software or
driver (Uninstall)
The screens may vary with the type of OS.
1 Select [start] (>> [Settings]) >>
[Control Panel], select the software or the
driver from [Add/Remove Programs] to
uninstall.
≥Uninstalling steps may vary depending on the
OS. Please refer to the user manual of your OS.
CAUTION:
If you disconnect the USB cable while the
Card Access Lamp is on, it may damage the
Card data.
OFF
ON
PC
LSQT0975_ENG.book 66 ページ ２００５年１２月１９日 月曜日 午前９時５１分