Filter
Top Products
14
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Supplying Power
Charge the Battery Pack on
the AC Adaptor
1 Connect and plug in the Power Cord
as shown.
• POWER Lamp will light.
• Remove the DC Cable, if attached,
from the adaptor.
2 Attach the Battery as shown to
charge.
• CHARGE Lamp lights up. It goes out
when charging is complete (approx.
1 hour). Expect approx. 2 hours of
operation (EVF usage) when fully
charged.
3 Remove the Battery.
Slide the Battery out and then lift up.
POWER Lamp
CHARGE Lamp
About the Flashing of the CHARGE Lamp
• Charge the Battery within an ambient temperature range of 10 °C (50 °F) and
30 °C (86 °F).
• If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
• The Battery is being charged, but charging is taking longer than normal.
• Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
Note
1 Insert the Battery Pack and slide it up
until it locks with a click.
Remove the Battery Pack
1
2
BATTERY
RELEASE
1
2
Insert the Battery Pack
1 While sliding the BATTERY RELEASE,
slide the Battery downward and
remove.
DV103.p12-14.p65 03/02/07, 10:4714