Filter
Top Products
12
CGR-D08A/1B
A
B
A
B
A
A
B
B
1 h.
2 h.
3 h 15 min.
1 h 20 min.
(1 h 5 min.)
2 h 35 min.
(2 h 10 min.)
4 h 30 min.
(3 h 40 min.)
5 h 20 min.
8 h 25 min.
(6 h 55 min.)
CGR-D16A/1B
CGR-D28A/1B
CGR-D53A/1K
CAMERA
VCR
CARD P.B.
1
MODE
ON
OFF
POWER
2
PUSH
BATT
4
3
1
2
Power Supply
ªUsing the AC Adaptor
1
Slide theViewfinder backward and then tilt it upward.
2
Insert the battery-shaped connector of the DC Cable into the
Battery Holder on the Palmcorder.
3
Connect the DC connector plug to the [DC OUT] Jack on the
AC Adaptor.
4
Connect the AC Adaptor and AC Cable.
≥Before disconnecting the power supply, set the [OFF/ON/MODE] Switch on
the Palmcorder to [OFF].
ªUsing the Battery
Before use, fully charge the battery.
1
11
1
Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
≥The [CHARGE] Lamp lights up, and charging starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
2
22
2
Attach the charged Battery to the Palmcorder.
Disconnecting the Power Source
Set the [OFF/ON/MODE] Switch
1
to [OFF] and, while pressing the
[BATT PUSH] Button
2
, slide the Battery or DC Cable upward to disconnect
it.
≥For other notes, see page 60.
~~~~~~~~~~~~~~~~~~~~~~~~
Charging Time and Available Recording Time
A
Charging Time
B
Maximum Continuous Recording Time
≥“1 h 20 min.” indicates 1 hour and 20 minutes.
≥Battery CGR-D16 is supplied.
≥The hours shown in the table are approximate hours. The numeric
characters in parentheses indicate the recording time when the LCD
monitor is used. In actual use, the available recording time may be shorter
in some cases.
≥The hours shown in the table are for continuous recording at a temperature
of 68 xF (20 xC) and humidity of 60 %. If the Battery is charged at a higher or
lower temperature, the charging time may be longer.