Panasonic PV-DV952 Camcorder User Manual


 
21
1tW
5tW
10tW
T
T
T
1
Z.MIC
1
PHOTO
PHOTO
PHOTO
PHOTO
1
PHOTO
SHOT
2
2
TAPE
CARD
STILL
1
PhotoShot Recording on the DV Cassette
With this function, you can record still pictures with sound for approximately
7 seconds each on the Cassette.
1
Slide the [TAPE/CARD] Selector to [TAPE].
2
Press the [PHOTO SHOT] Button in the Recording Pause Mode.
The Palmcorder records a still picture for about 7 seconds and then
switches back to the Recording Pause Mode.
Photoshot Recording results in slightly inferior image quality.
ªProgressive PhotoShot
TM
Mode
With the Progressive PhotoShot
TM
Mode, you can record still pictures with
higher resolution than with the normal PhotoShot Function.
After setting [PROGRESSIVE] on the [CAMERA SETUP] Sub-menu to
[ON] or [AUTO], press the [PHOTO SHOT] Button in the Recording Pause
Mode. [æ] is displayed.
1
This Function may not work with some function settings. (l 60)
If you select Card Mode, [PROGRESSIVE] is set to [ON].
ªFrame Moving Picture (Frame Mode)
Frame moving-picture recording makes it possible to obtain natural still
pictures with a high picture quality, even when the scenes involve a lot of
movement recording frame still pictures continuously at a rate of 30 frames a
second. (It is also possible to record sound.)
After setting [REC MODE] on the [CAMERA SETUP] Sub-menu to
[FRAME], press the Recording Start/Stop Button.
When [REC MODE] is set to [FRAME], the Digital Effect 1 Function
([EFFECT1] on the [DIGITAL EFFECT] Sub-menu) cannot be used.
For normal recording set [REC MODE] to [NORMAL].
ªContinuous PhotoShot
If the [PHOTO SHOT] Button is held down with the [SHUTTER] of the
Sub-Menu [OTHER FUNCTIONS] set to [ON], the Palmcorder will record still
images without interruptions every 0.7 seconds until the button is released.
The screen blinks and, at the same time, a shutter clicking sound is
recorded. (This function, however, is not enabled when Progressive
PhotoShot is set to [ON] or [AUTO].)
ªDigital Still Picture
When the [STILL] Button
2
is pressed, images become still pictures. When
the Button is pressed again, the Digital Still Picture Mode is cancelled.
We recommend that you press the [STILL] Button first at the position where
you want to record the picture and then press the [PHOTO SHOT] Button.
For the still pictures taken in the Continuous PhotoShot Mode or Digital Still
Picture Mode, PhotoShot index signals are not recorded.
~~~~~~~~~~~~~~~~~~~~~~~~~
Zoom In/Out Functions
It gives special effects to the Palmcorder by Recording objects close by or
with wide-angle shot.
1
For wide-angle shots (zoom out):
Press the [W/T] zoom lever towards [W].
For close-ups (zoom in):
Press the [W/T] zoom lever towards [T].
Zoom magnification is displayed for a few seconds.
Generally speaking, when the [W/T] zoom lever is pressed further towards
[W] or [T], the zooming speed gradually increases.
Taking Close-up Shots of Small Subjects (Macro Close-up Function)
When the zoom magnification is 1a, the Palmcorder can focus on a subject
that is as close as approximately 1.5 inches (35 mm) from the lens. With this,
small subjects, such as insects, can be recorded.
To Use the Zoom Microphone Function
Along with the zooming operation, the microphones directional angle and
sensitivity are varied for recording audio.
Set [CAMERA FUNCTIONS] >> [RECORDING SETUP] >> [ZOOM MIC]
>> [ON]. (The [Z.MIC] Indication is displayed.
1
)
The Zoom Microphone Function may not work effectively if the surrounding
noise is too loud.
When the [TAPE/CARD] Selector is set to [CARD], the Zoom Microphone
Function does not work.
For other notes, see page 60.