Filter
Top Products
Before using
12
LSQT0860
(39) Shoulder strap fixture
≥Put the strap through the fixture 1 and through
the stopper 2 so it will not come off. Extend
part 3 by at least 1 inch (2 cm).
≥Fit the other end of the belt similarly.
(40) Lens hood
In order to remove the lens hood, rotate it
counter-clockwise 1. In order to fit it, put into slot
2, and then rotate it clockwise.
Fitting the lens cap
Fit the lens cap to protect the surface of the lens.
1 Remove the grip belt. Run the end of the
lens cap cord through the hole in the grip
belt attachment and run the lens cap
through the lens cap cord.
≥The lens cap removed can be attached to the
lens cap fixture. (It cannot be hung if the grip
belt is used as a hand strap.)
≥To fit or remove the lens cap, hold both sides of
the lens cap with the tips of your finger and
thumb.
The one-touch free-style grip belt
ª To use as a hand strap
If you use the grip belt as a hand strap, then you
can carry or handle this Camcorder more easily.
1 Open the lock cover 1 by pinching the
projections 2 on both sides. Press the lock
button 3 to remove the grip belt.
≥When removing the grip belt, tightly hold the
Camcorder with both hands.
≥After removing the grip belt, restore the lock
cover to the original position.
2 Adjust the belt length.
1 Flip the belt.
2 Slide 1 in the direction indicated by the arrow.
3 Fix the belt.
3 Put your hand through the strap.
≥Hold the Camcorder not to cover the
microphones or the sensors with your hands.