Filter
Top Products
Record mode
26
LSQT0860
Recording still pictures on a card
while recording image onto a tape
You can record still pictures while recording
image onto a tape.
≥Set to Tape Recording Mode.
1 Press the [PHOTO SHOT] button fully while
recording image onto a tape.
≥For the number of still pictures to be recorded
on a card, refer to
-66-.
≥When recording pictures onto a card, the
recording start/stop button is disabled.
≥You can select a picture quality for still pictures
to be recorded. (
-27-)
≥In tape recording mode, the size of pictures that
can be recorded is [640].
≥In order to record higher quality still pictures,
you must use the card recording mode.
Check the recording
The last image recorded is played back for 2 to
3 seconds. After checking, the Camcorder will be
set to a recording pause.
≥Set to Tape Recording Mode.
1 Press the joystick during the recording
pause until the icon 1 appears.
2 Move the joystick down to select the
recording check icon [ ].
Blank search function
Searches for the last part of the image recorded
(unused part of the tape).
≥Set to Tape Recording/Playback Mode.
1 Set [BASIC] or [ADVANCE] >>
[BLANK SEARCH] >> [YES].
ª
Stopping a blank search midway
through
Move the joystick down.
≥If the cassette tape has no blank part, then the
Camcorder will stop at the end of the tape.
≥The Camcorder stops at a point approx.
1 second before the end of the last image
recorded. When you start recording at that
point, the image can be recorded seamlessly
from the last image.
Recording still pictures onto a card
(Photoshot)
≥Set to Card Recording Mode.
1 Press the [PHOTO SHOT] button.
ª
To record still pictures clearly
≥When zooming in on the subject with a
magnification of 4k to 10k or higher, it is
difficult to reduce the slight shaking from holding
the Camcorder by hand. We recommend
decreasing the zoom magnification and
approaching the subject when recording.
≥When recording still pictures, hold the
Camcorder firmly with your hands and keep
your arms stationary at your side so as not to
shake the Camcorder.
≥You can record stable pictures without shaking
by using a tripod and the remote control.
≥For the number of still pictures to be recorded
on a card, refer to
-66-.
≥The sound cannot be recorded.
≥While data is being recorded on a card, do not
operate the mode dial.
≥When the access lamp is lit, do not insert or
remove a card.
PHOTO
SHOT
1
PC
PHOTO
SHOT
LSQT0860ENG.book 26 ページ ２００４年１２月２２日 水曜日 午後２時３８分