Filter
Top Products
Preparation
- 18 -
Preparation
Attaching the Silicon Jacket
It is recommended to attach the silicon jacket to prevent unintentional opening of
the card/battery door or the terminal cover when using the camera in the mountains
or near water.
•
Check that this unit is turned off.
• Attach the Silicon Jacket in an area where there is no sand or dust.
Securely attach the Silicon Jacket to
the camera.
• Do not forcibly attach the Silicon Jacket to the
camera. It may damage the camera or Silicon
Jacket.
• Be sure to remove any foreign objects (sand etc.)
or water (sea water etc.) adhered inside the Silicon Jacket. If not removed, the foreign objects
or water may scratch or dirty the camera. We recommend that you remove the Silicon Jacket
from the camera, rinse, and then wipe away the water with a soft dry cloth.
∫ Maintenance after using
•
Do not forcibly remove the Silicon Jacket from the camera. It may damage the camera or
Silicon Jacket.
• Take the camera out of the Silicon Jacket, and check that foreign objects (sand etc.) or water
(sea water etc.) are not adhered.
• Rinse with water, wipe off water with a soft dry cloth, and dry the camera in a well ventilated
shaded area.
• Do not dry the camera with hot air from a dryer or similar. It may become unusable due to
deformation.
• Do not use chemicals such as benzine, thinner, alcohol, or cleanser, or soap or detergents.
• After use, remove the Silicon Jacket. Do not store the camera for a long period of time with the
Silicon Jacket still attached.