Others
- 186 -
• Is the Mode dial correctly set?
• Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P58)
• The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> When it is dirty, lightly wipe the surface of the lens with a soft and dry cloth.
• Was this picture taken with the flash at close range when the zoom is near [W] (1k)?
> Zoom in a little, and then take the pictures. (P52)
> Is this a picture taken in [PIN HOLE] in Scene Mode?
> Check that the exposure is correctly compensated. (P70)
• Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] (P116) to slower speed.
> Set Auto Bracket (P71), [HI-SPEED BURST] (P82), [FLASH BURST] (P83) in Scene Mode
or [BURST] (P117) of the [REC] Mode menu to [OFF].
• The focus range varies depending on the Recording Mode.
> Set to the proper Mode for the distance to the subject.
• The subject is beyond the focus range of the camera. (P49)
• There is camera shake (jitter) or the subject is moving slightly. (P51)
• Turn the power on again. If the operations are still not working normally, remove the power and
consult the dealer or your nearest Service Center.
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P43)
> When taking pictures at a slow shutter speed, use the Self-timer. (P69)
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The auto-focus and other operations are not working normally.
The recorded picture is blurred.
The Optical Image Stabilizer is not effective.