Filter
Top Products
The description below is the configuration of the priority stream that can transmit images without deteriorating
the image quality and refresh interval even when multiple users access concurrently.
Priority stream
[Activation]
Select “On” or “Off” to determine whether or not to use the priority stream.
• Default: Off
Note
• When “On” is selected for “Activation” of “Priority stream”, number of users who can access the camera
may be limited.
[Destination IP address(1)]
Enter the first destination IP address.
• Default: None (blank)
[Destination IP address(2)]
Enter the second destination IP address.
• Default: None (blank)
[Stream type]
Select either “JPEG”, “H.264/MPEG-4(1)” or “H.264/MPEG-4(2)”.
• JPEG: JPEG images will be transmitted.
• H.264/MPEG-4(1): H.264(1) (or MPEG-4(1)) images will be transmitted.
• H.264/MPEG-4(2): H.264(2) (or MPEG-4(2)) images will be transmitted.
• Default: JPEG
Note
• When “Best effort” is selected for “Transmission priority” of “H.264 (MPEG-4)”, bit rate will vary between
the maximum and minimum rates while images are being transmitted.
SW355
SW355
SW352
SW352
SF346
SF346
SF342
SF342
SF335
SF335
SW316L
SW316L
SW316
SW316
SP306
SP306
SP305
SP305
SP302
SP302
SW155
SW155
SW152
SW152
NP502
NP502
SW115
SW115
:
• When “H.264” is selected for “Recording format”, it is impossible to transmit H.264(2) images. In this
case, “H.264/MPEG-4(2)” is invalidated.
NP502
NP502
:
• “JPEG” is available only when a 1.3 mega pixel setting is selected for “Picture (Camera) mode”.
156 Operating Instructions
15 Configure the settings relating to the authentication [User mng.]