Panasonic WV-SP102E Security Camera User Manual


  Open as PDF
of 64
 
32
32
33
Configure the VMD settings [VMD area]
Click the [VMD area] tab on the "Alarm" page. (☞Pages13and14:Howtodisplay/operatethesetupmenu)
The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
Important:
•Thealarmoccurrenceindicationbutton(☞ page 8) will be displayed when motion is detected by the VMD func-
tion.
•Thealarmoccurrenceindicationbuttonwillbedisplayedwhenreceivinganalarminputofacommandalarm
•Dependingonthenetworkenvironment,notificationmaybedelayedevenwhen"Realtime"isselectedfor
"Alarm status update mode" on the "Basic" page (☞ page 18).
•Themotiondetectionfunctionisnotthededicatedfunctiontopreventthefts,fires,etc.Wearenotresponsible
for any accidents or damages occurring in case.
Off: Does not change the image quality upon alarm
detection.
Default:Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occur-
rence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
Default: 5 Normal
[Area]
When selecting a VMD area in the screen, it will be
numbered as area 1.
[Status]
Select"On"or"Off"todeterminewhetherornotto
activate each VMD area.
On: Activates the respective VMD area.
Off: Inactivates the respective VMD area.
Default:Off
[Detection area]
Adjust the size of the VMD area using the slider. The
smaller the selected value is, the higher the sensitivity
of VMD area becomes. The current value (1-10) will be
displayed on the right of the slider.
Default: 1
[Detection sensitivity]
Adjust the sensitivity of motion detection in the VMD
area using the slider. The settings can be configured for
each area individually. The larger the value is set, the
higher the sensitivity level becomes.
The current value (1 (low) - 15 (high)) will be displayed
below the slider.
Default: 8
[Delete] button
Click the [Delete] button corresponding to the area to
be deleted. The outline of the selected area will be
deleted.
 previous next