Panasonic WV-SP102E Security Camera User Manual


  Open as PDF
of 64
 
44
44
45
Configure the network settings [Network]
■ IPv4 network
[DHCP]
Select"On"or"Off"todeterminewhetherornottouse
the DHCP function.
Configure the DHCP server not to assign the same IP
addresses used for the other network cameras and PCs
whose IP address is unique. Refer to the network
administrator for further information about the settings
of the server.
Default:Off
The network settings and the settings relating to DDNS (Dynamic DNS) and SNMP (Simple Network management
Protocol) can be configured on the "Network" page.
The"Network"pagehas4tabs;the[Network]tab,the[DDNS]tab,the[SNMP]tabandthe[FTPimg.trans.]tab.
Configure the network settings [Network]
Click the [Network] tab on the "Network" page. (☞Pages13and14:Howtodisplay/operatethesetupmenu)
The following information is required to configure the network settings.
Contact the network administrator or your Internet service provider.
•IPaddress
•Subnetmask
•Defaultgateway(whenusingthegatewayserver/router)
•HTTPport
•PrimaryDNSaddress,SecondaryDNSaddress(whenusingDNS)
[IP address(IPv4)]
When not using the DHCP function, enter the IP
address of the camera. Do not enter an IP address
already in use (for the PCs and the other network cam-
eras).
Default: 192.168.0.10
Note:
•MultipleIPaddressesareunavailableevenwhen
using the DHCP function. Refer to the network
administrator for further information about the set-
tings of the DHCP server.
[Subnet mask]
When not using the DHCP function, enter the subnet
mask of the camera.
Default: 255.255.255.0
[Default gateway]
When not using the DHCP function, enter the Default
gateway of the camera.
Default: 192.168.0.1
Note:
•MultipleIPaddressesforthedefaultgatewayare
unavailable even when using the DHCP function.
Refer to the network administrator for further infor-
mation about the settings of the DHCP server.
 previous next