Filter
Top Products
Approximate time to be taken to save the set “Number of images” with the set “Transmission interval” will
be displayed.
[Image capture size]
Select the capture size of images to be transmitted to the FTP server or of an image to be attached to the
alarm mail.
When “4:3” is selected for “Aspect ratio”
SC384
SC384
SW175
SW175
SW174W
SW174W
ST165
ST165
:
QVGA/ VGA/ 1280x960
SW172
SW172
ST162
ST162
:
QVGA/ VGA/ 800x600
When “4:3 (VGA)” is selected for “Aspect ratio”
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
QVGA/ VGA/ 1280x960
When “4:3 (800x600)” is selected for “Aspect ratio”
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
QVGA/ 800x600/ 1280x960
When “16:9” is selected for “Aspect ratio”
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
SW175
SW175
SW174W
SW174W
ST165
ST165
:
320x180/ 640x360/ 1280x720
SW172
SW172
ST162
ST162
:
320x180/ 640x360
• Default: VGA
[Image compression rate upon alarm detection]
Select “On” or “Off” to determine whether or not to change the image quality of “Quality1” (®page 80) upon
alarm detection.
• On: Images will be transmitted with the image quality selected for “Image quality upon alarm detection”.
• Off: Does not change the image quality upon alarm detection.
• Default: Off
[Image quality upon alarm detection]
Image quality can be changed upon an alarm occurrence. Select the image quality from the following.
0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
• Default: 5 Normal
13.4 Configure the settings relating to H.264
recording [Alarm] (SW396/SW395/SC386/SC385/
SC384/SW175/SW172/ST165/ST162)
Click the [Alarm] tab on the “Alarm” page. (®page 47, page 49)
The settings relating to the recording H.264 data on the SD memory card when an alarm is detected can be
configured on this page. To operate recording, it is necessary to configure the settings relating to SD memory
card and the video data. (®page 58)
140 Operating Instructions
13 Configure the alarm settings [Alarm]