Filter
Top Products
– When a notification of the remaining capacity of the SD memory card has been provided (“Diag.”)
– When the SD memory card has become full (“Diag.”)
– When the SD memory card cannot be recognized (“Diag.”)
• Default: Off
[Alarm image attachment]
Select “On” or “Off” to determine whether or not to attach an image to the mail to be sent when an alarm is
detected.
• Default: Off
Note
• The settings for “Image capture size” of the “Alarm image” section on the [Alarm] tab (®page 138) will
be applied to the size of the image to be attached.
Destination of notification
[Address 1] - [Address 4]
Enter the destination mail address. Up to 4 destination addresses can be registered.
• [Alarm] checkbox: When the checkbox is selected, the mail notification will be performed upon an alarm
occurrence.
• [Destination address]: Enter the destination address.
– Available number of characters: 3 - 128 characters
– Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_),
and the hyphen (-).
To delete the registered address, click the [Delete] button respective to the desired address.
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
SW175
SW175
SW172
SW172
ST165
ST165
ST162
ST162
:
• [Diag.] checkbox: When the checkbox is selected, the mail notification will be provided in the following
cases.
– When notification of the remaining capacity of the SD memory card has been provided
– When the SD memory card has become full
– When the SD memory card cannot be recognized
[Mail subject]
Enter the mail subject.
• Available number of characters: 0 - 50 characters
[Mail body]
Enter the mail body.
• Available number of characters: 0 - 200 characters
Note
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
SW175
SW175
SW172
SW172
ST165
ST165
ST162
ST162
:
• Notification mail will be sent with the message “The capacity of the SD memory card is full.” when the
SD memory card becomes full, or “The SD memory card cannot be detected.” when mounting of the
SD memory card failed.
13.9 Configure the settings relating to Panasonic
alarm protocol [Notification]
Click the [Notification] tab on the “Alarm” page. (®page 47, page 49)
148 Operating Instructions
13 Configure the alarm settings [Alarm]