Filter
Top Products
Step 4
Mount the camera on the bracket.
q Attach the housing base to the mount bracket using
the hexagon screws (M5) attached to the housing
base* provided with the mount bracket.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf·ft})
The "REAR" mark of the housing base shall be direct-
ed to the wire hook section.
* Special screw: These screws are hexagon screws.
Use an M5 hexagon wrench.
w Make sure that the projection of the plate spring on
the upper side of the camera is located on the
"START" position. If not, turn the plate clockwise to
locate the projection at the "START" position.
e Connect the safety wire (accessory) to the mount bracket.
Refer to the operating instructions of the mount
bracket for further information about where to con-
nect the safety wire.
Even when not using the optional mounting bracket
(WV-Q122), connect the safety wire near to the cam-
era as shown in the example below.
Wire hook
section
Housing base
Hexagon screws (M5, 4 pcs.)
attached to the housing base
Plate
Plate spring
Projection
<Installation example>
Safety wire
r Attach the camera to the housing base. When attach-
ing the camera to the housing base, the positioning
pin shall be on the "REAR" side. Make sure that the
camera is securely attached to the mount bracket by
turning the camera to the direction of the arrow as
illustrated. Then, secure the camera to the mount
bracket with the screws removed when detaching the
housing base.
(Recommended tightening torque: 2.45 N·m
{1.81 lbf·ft})
* Special screw (Fixing screw): These screws are hexa-
gon screws. Use an M5 hexagon wrench.
Positioning pin
Overhead view
When the camera is secured
to the mount bracket
When the camera is
attached
Positioning pin
Fixing screws
(3 pcs.)
Camera
Housing base
20