Filter
Top Products
Initialize the camera
Use the INITIAL SET switch to reset the settings of the camera to the default.
IMPORTANT:
• Thesettingsincludingthenetworksettingswillbeinitialized.NotethatthepresetpositionsettingsandtheCRTkey
(SSL encryption key) used for the HTTPS protocol will not be initialized.
Step 1
Pull out the water-resistant cap by following steps 1 - 3 of
the “How to insert an SD memory card” section
(☞ page 18).
Step 2
Move the INITIAL SET switch to the right (ON).
The factory default is OFF.
Step 3
Move the INITIAL SET switch to the right, and then turn
on the power of the camera. The camera will start up and
all the settings including the network settings will be initial-
ized. The live indicator will light orange → light off → blink
orange → light orange. The initialization will be complete
when the live indicator lights orange. Before initializing the
settings, it is recommended to write down the settings in
advance.
IMPORTANT:
• Donotturnoffthepowerofthecameraduringinitial-
ization. Otherwise, it may fail to initialize and may
cause malfunction.
Step 4
Turn off the power of the camera.
OPEN LOCK
LOCKSTART
REAR
INITIAL SET switch
(OFF
ON)
Live indicator
Step 5
Move the INITIAL SET switch to the left (OFF).
(Refer to the illustration in Step 2)
IMPORTANT:
• IftheInitialsetswitchispositionedtothe“ON”side,
the camera cannot enter the normal operation mode.
Be sure to return the INITIAL SET switch to the “OFF”
position.
Step 6
Return the water-resistant cap and the main sunshield rear
cover to the original state by following steps 5 - 7 of the
“
How to insert an SD memory card
”
section
(☞ page 19).
Step 7
Turn on the power of the camera. (☞ Page 13)
When the power is supplied, the camera will enter the nor-
mal operation mode.
17