Panasonic WV-SW598 Security Camera User Manual


  Open as PDF
of 46
 
Specifications
• Basic
Power source: 24VAC±15%,PoE+device(IEEE802.3atcompliant)orTestedPoEinjector(60W)
Power consumption: AC power supply: 24 V AC (50 Hz/ 60 Hz)/ 3.5 A/ 55 W
Tested Power over Ethernet (Injector: 60 W)
: 54 V DC/ Approx. 1.0 A/ 50 W
PoE+ device:
54 V DC/ Approx. 470 mA/ 25 W (Class 4 device)
Standby power *
1
: AC power supply: 24 V AC (50 Hz/ 60 Hz)/ 720 mA/ 10 W
Tested Power over Ethernet (Injector: 60 W)
: 54 V DC/ Approx. 175 mA/ 9.5 W
PoE+ device:
54 V DC/ Approx. 165 mA/ 9.0 W (Class 4 device)
Ambient operating temperature:
–50 °C to +55 °C {–58 °F to +131 °F} (24 V AC/ Tested PoE injector (60 W)) *
2
–30 °C to +55 °C {–22 °F to +131 °F} (PoE+ device)
(During start-up: –30 °C to +55 °C {–22 °F to +131 °F}
(24 V AC/ PoE+ device/ Tested PoE injector (60 W))*
2
)
Ambient operating humidity:
Lessthan90%(nocondensation)
Storage temperature:
–50 °C to +70 °C {–58 °F to +158 °F}
Storage humidity:
Lessthan95%(nocondensation)
Monitor output (for adjustment):
VBS:1.0V[p-p]/75Ω,composite(BNC)
External I/O terminals: ALARM IN 1 (BLACK/WHITE IN)/ ALARM IN 2 (ALARM OUT)/
ALARM IN 3 (AUX OUT) (x1 each)
BLACK/WHITE IN, ALARM OUT, and AUX OUT can be used by changing the settings
of Terminal 1, Terminal 2, and Terminal 3.
Microphone/line input: ø3.5 mm monaural mini jack
Inputimpedance:Approx.2kΩ(unbalanced)
For microphone input: Applicable microphone: Plug-in power type
Supplyvoltage:2.5V±0.5V
Recommendedsensitivityofmicrophone:-48dB±3dB(0dB=1V/Pa,1kHz)
For line input: Input level: Approx. –10 dBV
Audio output: ø3.5 mm stereo mini jack (monaural output):
Outputimpedance:Approx.600Ω(unbalanced)
External speaker with an amplifier:
Output level: -20 dBV
Water resistance: IEC60529 (IP66, Against ingress of water with harmful effects powerful jetting)
Heater unit: Turns on automatically when the inside temperature drops below 10 °C {50 °F}.
Dimensions: ø229 mm x 357 (H) mm {ø9-1/32 inches x 14-1/16 inches (H)},
diameter of the dome: 160 mm {6-5/16 inches}
Mass: Main body: Approx. 5.0 kg {11.02 lbs}
Finish: Main body: Aluminum die cast with glazed melamine coating
(Coating color: Natural silver)
Sunshields*
3
: ASA resin coating (Coating color: Natural silver)
Dome cover section: Clear polycarbonate resin (Rain wash coating)
*1 This is the power consumed when only sending video signals, and when other functions such as pan/tilt, SD recording,
and the heater are not operated.
*2 When using the camera in low temperature environments, because the heater warms the camera to keep its internal
temperature above –10 °C {14 °F}, keep the power for the camera always turned on. Perform settings or startup
operations when the ambient temperature is –30 °C {–22 °F} or higher.
*3 It is impossible to remove the main sunshield.
•
Camera
Image sensor: Approx. 1/3 type MOS image sensor
Effective pixels: Approx. 2.4 megapixels
Scanning area: 5.38 mm (H) × 3.02 mm (V) {7/32 inches (H) x 1/8 inches (V)}
Scanning system: Progressive
36
 previous next