Filter
Top Products
44 November 2003 8000-A2-GB30-10
6.1.1.6 “atmInterfaceMaxActiveVciBits” Object (atmInterfaceConfEntry 6)
This object contains the maximum number of active VCI bits configured for use at this ATM
interface.
6.1.1.7 “atmInterfaceIlmiVpi” Object (atmInterfaceConfEntry 7)
6.1.1.8 This object contains the VPI value of the VCC supporting the ILMI on the ATM
Interface. “atmInterfaceIlmiVci” Object (atmInterfaceConfEntry 8)
This object contains the VCI value of the VCC supporting the ILMI on the ATM Interface. .
6.1.1.9 “atmInterfaceMyNeighborIpAddress” Object (atmInterfaceConfEntry
11)
In Hybrid Management Model, the value of this object contains the IP address of the
neighbor system connected to the far end of this interface, to which a Network Management
Station can send SNMP messages, as IP datagrams sent to UDP port 161, in order to access
network management information concerning the operation of that system.
Implementation Note: for those ATM interfaces over xDSL interfaces, the value of this
object is obtained from NMS station when the endpoint IP address is assigned for the
purpose of the persistent management of the endpoint.
Table 1-45. atmInterfaceMaxActiveVciBits
Interface atmInterfaceMaxActiveVciBits
DSLATM 6
AT MU P 10
AAL5 6
Table 1-46. atmInterfaceIlmiVpi
Interface atmInterfaceIlmiVpi Access
DSLATM 0 Read-Only
ATMUP 0 Read-Only
AAL5 0 Read-Only
Table 1-47. atmInterfaceIlmiVci
Interface atmInterfaceIlmiVci Access
DSLATM 0 Read-Only
AT MU P 16 R ead -On ly
AAL5 0 Read-Only