Filter
Top Products
Cable installation 25
Model 6081RC Network Access Server User Manual 2 • Hardware installation
Cable installation
This section describes installing the network interface cables.
Connecting the Ethernet ports
The Model 6081RC comes with three Ethernet ports. One Ethernet port is presented on the front panel via an
RJ-45 connector (figure 7), and two internal Ethernet ports that connect to the PICMG 2.16 backplane for inter-
card communication. All Ethernet ports will autosense the correct speed (10 or 100 Mbps) of the connection and
automatically negotiate half or full-duplex operation. This section describes connecting the front panel Ethernet
port on the Model 6081RC to an Ethernet LAN via an Ethernet hub, switch, or workstation.
Figure 7. Model 6081RC network and configuration ports
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
MODEL 6081RC Network Access Server
PWR
1 2
L2 LINK
ENET
CONFIG
10/100 ENET
READY
10/100 ENET
port
CONFIG
port
READY
LED
Handle
Handle
Mezzanine Card
Interface 2
Mezzanine Card
Interface 1
ButtonButton