Filter
Top Products
18 C1555M-G (12/07)
Change the Termination Jumpers on a Rear Panel Video BNC Card
In a single-bay, non-looping configuration (up to 256 cameras and 32 monitors), the jumpers must be set in the terminated position. Refer to the
Installing Additional Matrix Bays—Sideframing and Downframing section in the Appendix for details on termination jumper settings in multiple-
bay configurations.
When looping video out to another device (such as a DVR, VCR, or switcher), set the termination jumpers on the CM9770-RPC cards to the
unterminated position.
The termination jumpers are set in the appropriate position when your system is configured at the factory by Pelco. However, if you expand or
change your system, or purchase a replacement CM9770-RPC card, you may need to change the termination yourself.
Since the CM9770-RPC consists of two cards assembled together, you must access the termination jumpers on each card in a different way.
Access the termination jumpers on the right-side card as shown in Figure 8. Access the termination jumpers on the left-side card as shown in
Figure 9.
Figure 13 and Figure 14 illustrate sample sideframing configurations. Figure 15 illustrates a sample downframing configuration.
Refer to the Installing Additional Matrix Bays—Sideframing and Downframing section in the Appendix for detailed instructions on sideframing
and downframing.
Figure 8. CM9770-RPC Termination Jumpers—Right Card
Figure 9. CM9770-RPC Termination Jumpers—Left Card
1
2
3
31