Filter
Top Products
14 C4655M (2/11)
MOTION AREA SELECTION
The motion area is configured through the application window. Use the outline tool to draw a boundary around multiple areas.
Selecting a Motion Area
To select a motion area:
1. From the Linking menu, click Motion.
2. Click the Channel box, and select the channel you want to configure.
3. Configure the remaining settings.
4. In the Area window, drag the outline over an area from left to right (refer to Figure 6). The selected cells are highlighted in green.
Figure 6. Selecting a Motion Area
5. Repeat the previous steps (as necessary) to configure additional.
6. Click Close.
7. Click OK.
Clearing a Motion Area
To clear a motion area:
1. From the Linking menu, click Motion.
2. Click the Channel box, and select the channel you want to configure.
3. Drag the outline over the green highlighted cells from right to left (refer to Figure 7). The selected cells are cleared.
Figure 7. Clearing a Motion Area
4. Repeat the previous steps (as necessary) to configure additional motion areas.
5. Click Close.
6. Click OK.