Filter
Top Products
10 Pelco Manual C418M (8/97)
4.5 SUN SHROUD INSTALLATION
The sun shroud provides an air space between
itself and the enclosure to protect the enclosure
from the direct rays of the sun and reduces the
internal temperature of the enclosure approxi-
mately 10-15° F (-12.22°-9.44° C).
To install the sun shroud, perform the following
steps (see Figure 9):
1. Insert the mounting straps through the holes
in the standoffs inside the shroud.
2. Align the sun shroud.
3. Fasten the mounting straps securely around
the enclosure.
5.0 OPERATION
To ensure proper operation, the unit should be
installed as previously stated and wired in accor-
dance with Figures 7 and 8.
5.1 SYSTEM TEST
1. Power up the camera.
2. Check the operation of the lens functions such
as focus, zoom, and iris.
6.0 TROUBLESHOOTING GUIDELINES
1. Once the camera has been powered up and
no picture is present on the monitor, take the
following steps:
a. Verify that the video monitor has been
properly terminated.
b. If the monitor is properly terminated, open
and close the iris to see if a picture ap-
pears.
c. If adjusting the iris does not yield a pic-
ture, check the camera for proper voltage.
d. If the above do not restore a picture, con-
tact Pelco’s Technical Assistance Program
(TAP) at 1-800-289-9100.
7.0 MAINTENANCE
At a minimum frequency of once each year, the
enclosure should be routinely recharged. Addition-
ally, if the enclosure must be opened for servicing,
the enclosure would also need to be recharged.
The following instructions explain how to disas-
semble the enclosure, reassemble and charge it.
7.1 ENCLOSURE DISASSEMBLY
1. Disconnect the power from the enclosure.
2. Remove the mating connector from the rear
of the enclosure by turning the outer ring coun-
terclockwise until a click is felt; then pull the
mating portion of the connector off. You may
elect to remove the enclosure from its mount
which will make the disassembly process
much easier.
3. Remove the center cap from the Schraeder
valve. (See Figure 10, item 6).
4. Relieve internal enclosure pressure by de
pressing and holding down the center stem of
the Schraeder valve. (See Figure 10, item 6).
Figure 9. EH8000 Series Sun Shroud
Installation