Filter
Top Products
Pelco Manual C418M (8/97) 5
4.2 ENCLOSURE MOUNTING —
PAN/TILT
The enclosure can be mounted to a pan/tilt which
is mounted to a wall or ceiling.
For proper mounting, refer to the mounting instruc-
tions accompanying the specific mount and pan/tilt
you are using.
To insure suitable load bearing, a minimum of 1/4-inch
(0.63 cm) diameter fasteners should be used to secure
the mount and/or pan/tilt to the mounting surface.
The enclosure should be attached to the mount/
pan/tilt by a minimum of two 1/4-20 fasteners.
Always use a service loop, as shown in Figure 4
and Figure 5, in order to prevent unnecessary
entrance of water.
Figure 3. Typical Fixed Ceiling Mounting
Figure 2. Typical Fixed Wall Mounting
Figure 5. Typical Pan/Tilt Ceiling Mounting
Figure 4. Typical Pan/Tilt Wall Mounting