Filter
Top Products
4 Pelco Manual C418M (8/97)
Sand and Dust: MIL-E-5400T, para. 3.2.24.7.
Fungus: MIL-E-5400T, para. 3.2.24.8.
Salt Atmosphere: MIL-E-5400T, para. 3.2.24.9.
Explosion: MIL-E-5400T, para. 3.2.24.10.
(Design and product specifications subject to
change without notice.)
4.0 INSTALLATION
Please check the contents of your package before
proceeding with the installation of the equipment to
ensure that all the mating connectors and associ-
ated parts are present. If they are not, contact the
factory to obtain a replacement.
Note: Fasteners to attach the enclosure to the
fixed mount or pan/tilt are not provided in this
package and are not available from Pelco.
4.1 ENCLOSURE MOUNTING — FIXED
The enclosure can be mounted to either a wall
mount or a ceiling/pedestal mount.
For proper mounting, refer to the mounting instruc-
tions accompanying the specific mount you are
using.
To insure suitable load bearing, a minimum of 1/4-
inch (0.63 cm) diameter fasteners should be used
to secure the mount to the mounting surface.
The enclosure should be attached to the mount/
pan/tilt by a minimum of two 1/4-20 fasteners.
Always use a service loop, as shown in Figure 2
and Figure 3, in order to prevent unnecessary
entrance of water.
Figure 1. EH8000 Series Enclosures Dimension Drawing
ENCLOSURE A B C D E F G H I
EH8004 4.0 (10.16) 18.0 (45.72) 4.5 (11.43) 5.5 (13.97) 12.5 (31.75) 17.0 (43.18) 2.0 (5.08) 3.0 (7.62) 6.0 (15.24)
EH8006 6.0 (15.24) 22.0 (55.88) 6.5 (16.51) 7.0(17.78) 13.0 (33.02) 20.0 (50.80) 2.0 (5.08) 7.0(17.78) 6.0 (15.24)
EH8006-26 6.0 (15.24) 28.0 (71.12) 6.5 (16.51) 7.0(17.78) 16.0 (40.64) 26.0 (66.04) 2.0 (5.08) 7.0(17.78) 6.0 (15.24)
EH8008 8.0 (20.32) 28.0 (71.12) 8.5 (21.59) 9.0 (22.86) 16.0 (40.64) 26.0 (66.04) 2.0 (5.08) 7.0(17.78) 6.0 (15.24)
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES