Filter
Top Products
190
5
Settings
3
Use the four-way controller (45)
to choose the image for the start-up
screen.
Only images available for the start-up screen
are displayed. You can also choose from the
Guide Display Start-up Screen and the pre-
installed screen already stored in the
camera.
4
Press the 4 button.
The start-up screen is set.
Pixel Mapping is a function for mapping out and correcting defective
pixels in the image sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1
Press the 3 button in capture mode to display the
[W Setting 4] menu.
2
Use the four-way controller (23) to select [Pixel
Mapping], and press the four-way controller (5).
The [Pixel Mapping] screen appears.
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card/built-in memory is
formatted.
• The start-up screen is not displayed when set to [Off].
• The start-up screen is not displayed when the camera starts up in
playback mode.
• Images taken at F (Digital Panorama) mode and movies cannot be
used as the start-up screen.
Correcting Defective Pixels in the Image Sensor
(Pixel Mapping)
When executing Pixel Mapping, display the [W Setting 4] menu in
capture mode. Pixel Mapping cannot be selected when the [W Setting 4]
menu is displayed in playback mode.
100-0017
100-0017
Cancel
Cancel
OK
OK