Filter
Top Products
135
6
Settings
choose the PENTAX logo screen or the Guide Display Start-up screen
already stored in the camera.
4
Press the 4 button.
The start-up screen is set.
Pixel Mapping is a function for mapping out and correcting defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1
Use the four-way controller (23) to select [Pixel
Mapping] in the [W Setting] menu.
2
Press the four-way controller (5).
The [Pixel Mapping] screen appears.
3
Use the four-way controller
(23) to select [Pixel
Mapping].
4
Press the 4 button.
Defective pixels are mapped and corrected.
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card/built-in memory is
formatted.
• The start-up screen is not displayed when set to [Off].
• The start-up screen is not displayed when the camera starts up in
playback mode.
Correcting Defective Pixels in the CCD Sensor
(Pixel Mapping)
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Charge the battery
or replace it with a fully charged battery.
Pixel Mapping
Pixel Mapping
Cancel
Checks the image sensor
and corrects defective
pixels
OK
OK