Filter
Top Products
13
Advanced Operation
How to adjust the EV compensation?
To adjust the EV compensation, perform the
following:
1. Set the operating mode to CAPTURE .
2. Press the MENU button. The Capture menu
appears.
3. Select the EV COMPENSATION item by the
arrow buttons (/) and then press the OK
button to confirm.
4. Use the arrow buttons (/) to select the
desired exposure value.
*The effective range is from -2.0 to +2.0 in steps of
0.3 EV.
5. Press the OK button again to make the
change. The cursor returns to the CAPTURE
MENU.
This setting is reset to 0.0 when the camera power is off.
How to adjust the White Balance?
To adjust the White Balance, perform the
following:
1. Set the operating mode to CAPTURE .
2. Press the MENU button. The Capture menu
appears.
Reference:
The above table is the 6 possible combination
of each recording pixels and quality setting.
How to set the Flash?
The Flash Mode can only be set under CAP-
TURE mode. There are 4 modes available:
Auto, Red-Eye, Flash ON and Flash OFF. The
default setting is Auto. To change the setting,
press the Mode button a number of times until
the desired one is selected.
Mode Description
Flash is enabled automatically in low
light conditions
Auto Mode with Pre-Flash to reduce red
eye effect
Flash is always enabled
Flash is always disabled
Auto
Red-Eye
Flash ON
Flash OFF
The setting is conserved even if the camera power is
off.
The flash effective range is 0.4m - 2m (1.3feet
- 6feet).