Filter
Top Products
61
3
Basic Operations
7
Point the remote control unit
towards the front of the camera
and press the shutter release
button on the remote control.
The operating distance of the remote
control unit is about 5 m from the front
of the camera. The shutter will be
released immediately or approximately
three seconds after the shutter release button on the remote control unit
is pressed.
When the picture is taken, the self-timer lamp lights for two seconds and
will then resume blinking.
• Exposure may be affected if light enters the viewfinder. Attach the provided
viewfinder cap or use the AE lock function (p.142). (Ignore the light entering
the viewfinder when the exposure mode is set to a (manual) (p.138).)
• Remove the Eyecup F
L by pulling one side upward when using accessories
such as the viewfinder cap.
• Turn the power off to stop the remote control operation after it has been
activated.
• The remote control may not operate in backlit conditions.
• The remote control does not work while the flash is being charged.
• When using the built-in flash, raise the flash into position first.
• The camera automatically returns to single frame shooting after the remote
control shooting mode is left unused for five minutes.
• The remote control unit battery can send a remote control signal about
30,000 times. Contact PENTAX service center to exchange the battery. (This
will involve a fee.)
5m
Removing the Eyecup FL Attaching the Viewfinder cap